WK HPI 86810 Axle GEAR SHAFT 5 x 6 x 29mm keyed on one side or both?

northerngames

northerngames

Well-Known Member
WK HPI 86810 Axle GEAR SHAFT 5 x 6 x 29mm keyed on one side or both?

I ask becuase I want to use a set of the e savage gears with it and the pic of the e savage's bevel pinion look's like the shaft above that goes into has been keyed on both side's of the shaft.

I pulled my integy axles apart and the axle gear shaft is only smoothed out on one side so it is only keyed on one side and goung by this pic it show's it would need to be keyed on both side's.

http://www.rcplanet.com/ProductDetails.asp?ProductCode=HPI82047&click=107101&Click=106800&gdftrk=gdfV23720_a_7c1734_a_7c7524_a_7cHPI82047


I dont have a stock one to compare and was hoping maybe somebody here has a stock set laying around or rebuilt there's and perhaps recall's it having one keyed side or two.

if it is two then I need to order a set of the stock one's also so I can get them e savage gears in there.
 
northerngames

northerngames

Well-Known Member
and that is the axle gear shaft and there smooth on two side's like the one's that come out of the trans gear case?

if so that stink's becuase I'm gonna have to grab a set of them too now lol.

the integy one's are only keyed/smooth on one side :mad
 
northerngames

northerngames

Well-Known Member
cool thank's for helping look's like I need to order a pair of them.

so yeah unless your only after the aluminum housing's and the outer goodies that they come with inner guts of the integy aluminum 2.2 axle set's are not very good for over sized WK's.

stockers they may be great but there not for this build.
 
B

BJoeHandley

Well-Known Member
Short of the trans case that has gone into the Grave Robber and the steering stuff on my XJ WK, I try to stay away from Integy stuff, I even do my damnedest to try and avoid selling it too.
 
You must log in or register to reply here.
Top