My CF Terminator build

1

1Badclod

Moderator
Moderator
Hey guys, I dont post much here. But I figured why be dedicated to one site lol. After buying multiple things from here I may aswell show you what Im building.

I got my axles dirt cheap litterally pics say so :rolleyes Cant complain to much cause like I said they were cheap!
I cleaned one axle up and made sure everything was good to go in it and installed bearings and re-greased everything. Other axle will be getting cleanded up later tonight.

Im going with a CPE CF Terminator chassis. I love the looks of CF chassis, Ive had most all of Bretts racing chassis's and its a tie between the terminator and the old CPE Evolution chassis. Not sure what Im going to do for motors and esc's yet but I know it WILL be brushless.

I enjoyed my Predator chassis that had 7700kv's with dual SV2's I know some may say thats too much but it really was fun and never got hot!

So on with the pics

Axles one clean and the other the way they looked when I got them.



The theme of the truck is Gunslinger, Thanks to Jon! Ive always love Gunslinger and he had a great deal on a body so I snagged it:D


The wheels will have CPE wideners installed here soon aswell. The stock tires will end up going too and replaced with Rumblers. Down the road I would like to purchase some RC4WD replica white wheels for it, but these will do for now





More progress to come very soon.
 
1

1Badclod

Moderator
Moderator
Well I hit the grind stone today! I got her into a ROLLER!!

I still need to fine tune it im sure but that will wait until I get electronics.
The shock retainers will be replaced as well as the shock springs but you get the jist

Say Hello to GUNSLINGER!!!!!!!!

I got so into building this truck that I started doing well taking pictures then I fell off the wagon and got in a zone and forgot to take step by step pics :( I guess I could rip it all apart and do it over agian if need be

Im not real good with a dremel yet, but I attempted to grind down the steering stops and the inner ring on the hub for better steering.



Installed bearings in the tranny and gears, also put hex head screws in the case




All laid out on the table ready for assembly. I didnt realize the rear lock outs are not the ones I wanted but will get the right ones later on.



And this the only pic of the step by step


And in a roller!





Up next is electronics :emot26:
 
1

1Badclod

Moderator
Moderator
Note to self dont shave tires unless your going to shave it the right way. LOL I shaved it back-asswards
 
Last edited:
You must log in or register to reply here.
Top