KK2 Remix.....

SWMS

Supporting Manufacturer
RCMT Sponsor
It's time that the original KK2 prototype gets a change up in powertrain. She's been running axial gear for a few years, and I think it's now time to drop in some classic Clod motor on axle action!

Here are a few pics for where she's at now.



 

SWMS

Supporting Manufacturer
RCMT Sponsor
And Clod axles going in. They fit so nice. I like using Clod gear that I am so familiar with.



Here's a front and rear view of the new SWMS dual shock mount bracket.


 

SWMS

Supporting Manufacturer
RCMT Sponsor
I had some spare time to perform some more wrenching.

I put a little bit of some attention to the shocks. I added some rubber bumpers to limit how much travel I get at full bump. The motor to chassis side plate clearance gets a little tight and this helps prevent any possible contact.




I also took the time to mount up the dual SV3s.


She's almost done. I just need to tie up some wire routing. I may take the time to rebuild the shocks.
 
Top