king -t low rider #208 convertible

SEMIJOE

Moderator
Moderator
RCMT Sponsor
ive been wanting to do a low rider

im useing all stock parts from the king kit, rc4wd low profile tires, ball bearings, 2x servos and my alum rails . want to show the adverage joe/newbies that you dont need a ton of money to make a pretty nice truck

total truck build with paint too was 430.00 usd

the rail i cut 28 inches long, paint pure white

rear cross floor and fifth wheel plate was paint silver leaf
fifth wheel painted white

interior will be gray and white

i want to see how low i can go useing stock parts

between suspension, axle cut and tires i was able to get it to 66mm from ground to top rail

i built the truck for show only so theres no shocks. which is fine, the leafs are stiff enough

the front bumper is 5 mm off the ground. under the hood is plenty room for the electronics

the transmission is 11mm off ground. rear mud flaps i had to cut off 5mm

the cab is going to be pretty kool to, i chop top 10mm and made it an convertible, ive added 45mm to side hood and slanted the grill 6mm


 

SEMIJOE

Moderator
Moderator
RCMT Sponsor
well six hours later i finally have one fender done

it was well worth the time too




 

SEMIJOE

Moderator
Moderator
RCMT Sponsor
while im waiting on fender to dry i will get started on the exhaust. this wont have exhaust stacks. but a regular exhaust going under the frame
i made a muffler to. this is how i did the muffler





 
Top