Integy Steering Knuckles with Hot Racing Axle Tubes ???

[Bane75]

I have the Hot Racing axle tubes and steering knuckles. I got the kingpins through the ball bearings in two of the steering knuckles and the other kingpins won't pass through the center of the ball bearing. I actually broke a ball bearing trying to get it through. I was wondering if the Integy stearing knuckles would work with Hot racing axle tubes. Also the Hot Racing kingpins strip very easily, I had to slot one with a dremel tool so I could use a flat head screwdriver to tighten it !

 

[Ball Racing]

Well either there was a burr on the screw or you had the wrong bearing.
You should be able to find a new bearing or get a new bolt and use the same knuckles.

 

[Bane75]

Well either there was a burr on the screw or you had the wrong bearing.
You should be able to find a new bearing or get a new bolt and use the same knuckles.

I was thinking maybe I could sand down the bolts a little. I know the bearings are correct. Thanks!