Ground pounder shafts........

S

soulja55

Well-Known Member
i am working on a Wheely King project.... and have another that i am about to start... and i see everyone changing drive axles and i have plan to do the same with a revo shaft. however....i remember purchasing the ground pounder aluminum shafts for a GP i had....and i was curious to know if these shafts would fit on the wheely king. they were as tuff as nails....and if i could find out if the shaft would be long enuff for the wheely king and the hole saize diameter close with the crawler conversion it would be a big help......
 
C

cpe mt

Moderator
Moderator
RCMT Sponsor
Pretty sure the WK uses a 6mm tranny output shaft while the GP has a 5mm output.
 
R

rmahar

Member
I have a custom wheely king with a 12.25 wb and i used scx10 mip driveshafts with revo 6mm outputs.hope this helps.
 
You must log in or register to reply here.
Top