GP 14mm hexes?

[rammmit]

Hey Mike, I know you are extremely busy, was just curious if you had been able to look into doing 14mm hexes for the Ground Pounders?

Thanks,
Jeremy

 

[etzaras]

Try these it will probably be a lot cheaper.
Traxxas # 4954R the only problem is they use a thicker pin. You just need to drill out the holes on your axle stubs to accommodate the thicker pins.

 

[rammmit]

Thanks I will check those out.

 

[mhesse]

Sorry Jeremy
I haven't looked at them yet. Could be in the near future just been swamped with a couple of big production orders.
I will make some just need to get so time freed up to draw them and make a set or 2.

Evan thanks for posting an alternative, i feel a little better that I haven't had time to look at these if there is a decent option for the time being.

Mike

 

[rammmit]

No problem Mike. I know you are busy was just throwing it out there. Do what you need to get done, if you make some let me know. But no hurries here, just was curious is all. Keep up the great work, we all appreciate your work!

Thanks again, Jeremy

 

[Brian34]

Traxxas Maxx hubs, aluminum 14mm hex, available at Tower.

 

[HawnMT]

I'm not entirely positive about this but I think these are small pin 14mm hexes:

https://store.rc4wd.com/14mm-Steel-Wheel-Hub-for-axles-4_p_354.html

 

[rammmit]

I'm not entirely positive about this but I think these are small pin 14mm hexes:

https://store.rc4wd.com/14mm-Steel-Wheel-Hub-for-axles-4_p_354.html

Funny you mention those, I just ordered a set of those, should be here in a few days.

For now I modified a set of aluminum 14mm hexs from a Wheely King to work.