Flm Question

[twisted8]

hello, i just bought the arm kit off ebay. it was supposed to be the extended kit but it wasnt.it was the standerd, oh well.my question is what are the two sets of holes in the front arms for ? i know they are to extend the front width but why ? is it to use front rims on the rear and rear on the front to give a little extra width ?

thanks

 

[Rapko]

You should be able to use front rims on all four corners. If you would of bought the extended version you would of had to use the stock setup on front and back but it'd still be just as wide.

 

[twisted8]

the auctionj was for the extended kit.but when i got it it wasnt. the rear arms are the same length as stock. im just trying to figure out where there are two hinge pin holes in the front.

 

[Rapko]

The only reason is to give the user more options.

 

[twisted8]

how wide is your pede with the exteded kit ?

 

[Rapko]

My pede is this wide (see pic) BUT you have to remember that the extended kit that I got wasn't compatable with the same offset rims all around. I sold the rear arms because they were longer than the fronts and then bought FLM's stock length rear arms. Basically all you need to do is buy the FLM front arms and then decide if you want to spend the extra cash on the rears. That way your pede will be wider than stock and you can use the same rim on all four corners.




You can definitely notice the pede is a bit wider from stock.