Bevel gear question

[FlashGordon1]

Hello members,I have a question on the Axial Wraith. If you could look inside your manuals on page 11. At this time I am building a monster truck using these axles. When you're putting the front and rear differential together,by using ax30392 (38T bevel gear/13T). I do see that this kit has an option parts. I would like to use ax30401-36T/14T for both rear and front. Or stock in the front and ax30401-36T/14 for the rear.
Now if I am right. Is the ax30401-36T/14 listed as over drive?

 

[JKRacing37]

If you overdrive one end - overdrive the front. This will "pull" the truck through corners and help it handle better. Overdriving the rear will cause a big time push in corners and have absolutely no benefit.

Also, I don't see any advantage to changing both ring and pinions to the optional gearing. If you are going to run the same gearing in each end. Stick with the stock gears and save yourself some cash.


Sent from my iPhone using Tapatalk

 

[KingClod27]

I already told you and like John just said, use stock stuff for now...dont make this overly difficult. get the truck built and then do those small upgrades...Those type of upgrades are "fine tuning"..you need to see how the truck drives before you start upgrading parts....