The Zilla 5 that was made was a one off years ago.
They are supposed to be coming out with a new chassis. It will be caked zilla 5 but will be nothing like the race chassis made before.
Here is the link to there site. http://midwestmini.com/
You have to cut the bead on any tire except the jc tires. The bead isn't as wide on the wheel.
If you cab find someone with the Dragon wheels. They come with 32mm hubs. If I had any I would let you have them. I will never run any that wide.
Still amazing to me. I have around twenty sets and a few may wobble just a little but no more than any other wheel I have ran. I do know that I have fixed a few other peoples wheels that the center hub was bolted in to tight to one side causing a wobble. I always go back and forth putting the...
You have to use the 25mm offset on the ground pounder because of how the knuckle is made.
You can cut the knuckle down or get a set of Hesse Machine knuckles to clear a narrower offset.
That is amazing that yours wobble that bad. Normally if they are off it is because the center hub is tightened down off or to tight. I have tons of these wheels and have very little wobble in any of them.
If you do strip a center it can be replace so that is nice.
You can add a bead lock...
I don't remember that one. It looks a little like a phantom build but has some differences.
I see you want A-1 stuff. I have a lot I am thinking about selling. Email me if your interested [email protected]
Nice to see someone close with a clod. I am in Scottsville just south of BG. There is a hobby shop in BG but they don't have any clod parts. I need almost everything for a clod or I can point you in the correct direction on line when you find out what all you need.