Recent content by lydiasdad

It looks good. I like it. How does it drive?

Video Finally Better late then never right? Took a couple short vids of it finally. I plan on gearing up slightly as it has plenty of torque and runs very cool. https://www.youtube.com/watch?v=qtVSSDtNuIE https://www.youtube.com/watch?v=8ycRgDqfQ4E

I'm going to try this weekend to start a new thread showing what is needed and how to install it. I pulled the assembled slipper from my old evader and installed it directly to the wk tranny. The only thing different is the addition of the threaded stud into the wk tranny output shaft...

I'm glad you got the slipper figured out. It's worked great for me.

What problem are you having installing the slipper? The threaded studs linked on my thread are incorrect, they are too short. Is that the problem? I need to do a thread with pics on how to do it.

@northerngames I'm not sure about the speed controller using one battery. The esc's bec is powered by one of the two batteries. If you plan on jumpering one of the battery leads you might burn up the esc if running higher voltage. I'll have to check my gearing, I ruptured a disk in my back...

Very nice truck! Looks really clean. I've been using that two speed tranny in my Jugg2. I had to upgrade to the RR slipper assembly (that was before the revo slipper existed) and has been great. I run in first gear 95% of the time and only use second to do high speed runs to show off:)

This comes directly from Castle Creations.. A high power capable brushless motor in electrical engineering and physics terms, has unlimited torque. A high power brushless motor?s limit to torque in an RC vehicle is not within the bounds of the motor itself so much, but rather falls on...

Glad I could help.

So sorry to hear about the accident. I just found this thread and your work is amazing. Makes me realize how truly hack my builds are:o

I did not lube any part of the slipper assembly and it's worked great. If your using the stock wheely king spur I think that is your problem. If I recall that spur is extremely soft.

Yep, next weekend. Along with my 775 Titan powered wheely king.

I posted this on clodtalk a while back but wanted to share it here. 820 sized Dewalt motor, which is unbelievably powerful, fed buy a Novak super duty and 6s LiFe. I've measured over 1800 watts from this motor! CF side plates, servo mount and links. Old E-maxx tranny with steel idlers and 2...

I only use 2 screws to secure the spur to the slipper plate. I have almost no wobble in the spur and my mesh is consistant. After many runs the spur/pinion has no signs of wear. What spur are you using? I apologize again for linking to the wrong size set screws. I would be willing to buy them...

That looks fantastic! Very nicely done.